Panasonic AG-VP320 - Manual (Page 10)

10
Location of Controls (continued)
The following table shows the status of the output jacks when in VCR or DVD mode.
• PROG functions on the remote are not available when using Component Video Output and
S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press PROG.
To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2). When PROGRESSIVE OUT is set to “ON” in the DVD Main Menu (p. 55), a Progressive
Scan signal is output from the Component Video Output Connector.
Notes
• The screen may shift off-center when using progressive output. Please adjust the screen position if
this occurs. (Refer to your TV manual.)
• If the television is not progressive compatible, a progressive scan picture is not available.
Connect the Video Output or S-Video Output connector (see p. 12, 13) and set PROGRESSIVE
OUT to “OFF” in the DVD Main Menu. (See p. 55.)
Rear View of DECK
AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 0.9 W of
electrical power in off mode.
S-Video Out Connector
(DVD Only)
pp. 10, 13
Component Video Output
Connector (Y, P
B , P R )
(DVD Only)
p. 13
Audio Output 1
Connector (L/R)
p. 12
Optical Digital Audio
Output Connector
(DVD Only)
p. 15
Video Input
Connector
p. 35
Video Output
Connector
p. 12
Audio Output 2
Connector (L/R)
p. 13
VHF/UHF Antenna Input Terminal
p. 12
VHF/UHF Antenna Output Terminal
p.12
Audio Input
Connector (L/R)
p. 35
Video Output
Audio Out 1
Audio Out 2
Component
Video Output
S-VIDEO OUT
VCR
DVD
YES
YES
N/A
YES
N/A
VHF/UHF
Antenna Out
YES
YES
Note
Bold: VCR Function Italic: DVD Function
Bold Italic: VCR and DVD Functions