Pioneer DV-400V-S - Manual (Page 12)

Connections 02
12
En
Connecting using the S-video
output
If your TV (or other equipment) has an S-video
(S1) input, you can use the S-video output on
this player instead of the standard (composite)
output for a better quality picture.
• Use an S-video cable (not supplied) to
connect the S-VIDEO OUT to an S-video
input on your TV (or monitor or AV
receiver).
Line up the small triangle above the jack with
the same mark on the plug before plugging in.
Connecting using the
component video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other
equipment). This should give you the best
quality picture from the three types of video
output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
Watching progressive scan video
from the component video outputs
This player can output progressive scan video
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see
Video Output settings on page 35.
When the player is set to output progressive
scan video, the
PRGSVE indicator lights in the
front panel display.
P R
P B
Y
COMPONENT VIDEO OUT
VIDEO OUT
S-VIDEO OUT
DIGITAL AUDIO OUT AUDIO OUT
HDMI OUT
L
R
COAXIAL
TV
To S-video input
P R
P B
Y
COMPONENT VIDEO OUT
VIDEO OUT
S-VIDEO OUT
DIGITAL AUDIO OUT
AUDIO OUT
HDMI OUT
L
R
COAXIAL
TV
To component
video input
DV400V_KUC_EN.book 12 ページ ２００７年３月１４日 水曜日 午後８時８分