Pittsburgh Corning 807 - Manual (Page 4)

Page 4 For technical questions, please call 1-800-444-3353. Torque
Wrenches
Retighten Lock Knob by turning it all 7.
the way clockwise.
direction
switch
8. Set the Direction Switch for clockwise
or counterclockwise operation. The
Switch shown above is in position for
clockwise operation.
Place socket onto the nut or bolt and
9.
pull handle gradually until a click is
heard or felt. do not pull beyond
that point; the click indicates that the
torque setting has been reached.
Stop pulling and the Torque Wrench
10.
will automatically reset.
When finished, set the Torque to the
11.
lowest torque setting (not lower than
the lowest setting) before storing
indoors out of reach of children.
ClEANiNg, mAiNTENANCE,
ANd lUbRiCATiON
TO pREVENT
iNjURy FROm
TOOl FAilURE:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
bEFORE EACH UsE, 1. inspect the
general condition of the tool. Check
for loose hardware, misalignment or
binding of moving parts, cracked or
broken parts and any other condition
that may affect its safe operation.
If the Torque Wrench has not been
2.
used for some time, turn the knurled
handle (CW and CCW) several times
to re-lubricate the internal workings.
Then, operate at a low torque setting
several times. This ensures proper
operation. do not turn knurled
handle below the lowest torque
setting.
Wipe Torque Wrench with a cloth to
3.
clean. Do not immerse in any cleaning
solution. This would damage the
internal lubrication.
The Torque Wrench was calibrated
4.
and tested to ± 4%. Periodically have
the Wrench calibrated and serviced
by a qualified technician.
Store inside case in a clean and dry
5.
location.
Note: Replacement parts are not
available for this item.