POSIFLEX Business Machines TP/LT- 5600 - Manual (Page 17)

Part 17
Automatic Power On Control
The system may also turn on according to some preset conditions
such as Modem Ring Up and Alarm Clock Wake Up or LAN Wake Up.
To utilize Modem Ring Up or Alarm Clock Wake Up function, the
user should enter the CMOS setup by pressing “Del” key at system boot up,
choose for “PM Wake Up Events” in “Power Management Setup” and make
the “Ring Power Up Control” enabled for Modem Ring Up or select the
“Power Up by Alarm” for Alarm Clock Wake Up. Save the configuration and
exit the CMOS setup program. The Preset Power On Control will then be
ready. For LAN wakeup, an operating caller system connected through LAN to
the system is required. It also requires a qualified networking technician to
check the LAN chip ID of the system for the caller system to wake up.
When the Jiva system is turned off after a successful boot up, the
preset automatic power on functions will keep monitoring for the preset
conditions and turn on the system when the preset conditions are met.
Please note that if the Jiva system is improperly turned off before a
complete boot up procedure, the above preset power on control functions will
be disabled until next turning off after a complete boot up.
DISPLAY ISSUES
Main LCD Display
For best viewing result please set your display resolution at 1024 x
768 with high color.
In configuration of system memory for TP/LT-5600/5700/5800, max.
64 MB can be shared as the video memory and max. 128 MB for TP/LT-8000.
VGA Port
The VGA port in the Jiva system supports TM4115 touch monitor,
LM6212 LCD monitor or TM7112 touch monitor if there is no base mount 2
nd
LCD display. This port supports either mirror mode (identical image) or
extended mode dual display function for WinXP. To support the DC power to
these Posiflex monitor, use the DC adaptor to connect into the monitor (for
TM-4115 / TM-7112) or its VGA cable (for LM-6212) or use Posiflex VGA +
power cable and set an internal jumper in Jiva main unit to supply the required
power through the VGA connector (for LM-6212). Do not connect other
monitor to this port before the power in this port is disabled.
CUSTOMER DISPLAY
Please follow the instructions on the manual that comes along with
the customer display PD-2501 or PD302 when it is installed.