Patton electronic 1082 - Manual (Page 15)

15
Configuring DIP switch “S2”
Use the eight DIP switches in S2 to enable 19.2 kbps or 144* kbps syn-
chronous operation and set the loopback modes. The following table
summarizes default positions of DIP switches S2-1 through S2-8.
Detailed descriptions of each switch follow the table.
Switches S2-1: 19.2 kbps or 144 * kbps Synchronous Rate Enable
Use switch S2-1 to allow the Model 1082/I and Model 1082/144/I to oper-
ate at the 19.2 kbps
synchronous data rate, or to enable the Model 1082/
144/I to operate at the 144* kbps synchronous data rate.
Note To operate at 19.2 kbps or 144 kbps, set switches S1-1 and S1-2
to the OFF position and switch S2-1 to ON (see section “Configur-
ing DIP Switch S1” on page 12).
* 144 kbps data rate is only available on the Model 1082/144/I.
19.2 kbps rate is available on all Model 1082 series modems
except
for the 1082/144/I.
S2-1 Activation Description
Off Disabled Synchronous data rate is 32–128 kbps as
defined by switches S1-1 and S1-2
On Enabled Model 1082/I operates at synchronous 19.2 kbps
data rate (see note). The Model 1082/144/I oper-
ates at 144 kbps synchronous data rate (see note)
S2 Summary Table
Position Function Factory Default
S2-1 19.2 or 14 4* k bps Enable Off
S2-2 Front Panel Switch Disabl e Off
S2-3 Reserved Off
S2-4 Reserved Off
S2-5 Reserved Off
S2-6 Reserved On
S2-7 Reserved Off
S2-8 Reserved Off