Document requirements, 4 setting the original, Setting the original – Panasonic KX-MB271 User Manual

Page 17: 4 setting the original, Preparation 17, 1 using the scanner glass 1, 2 using the auto document feeder 1

Advertising
background image

2. Preparation

17

For assistance, please visit http://www.panasonic.com/help

Document Requirements

2.4 Setting the original

2.4.1 Using the scanner glass

1

Open the document cover (

1).

2

Place the document FACE DOWN on the scanner
glass (

2), aligning the top left of the document with

the corner to which the m mark points.

3

Close the document cover.

Note:

L

Confirm that there are no documents in the auto
document feeder.

L

Place the original onto the scanner glass gently and
do not press down too firmly to avoid malfunction.

L

If the original is a thick book, do not close the
document cover.

L

Check that ink, paste or correction fluid has dried
completely.

L

Effective scanning area is as follows:
Effective scanning area

L

Shaded area will be scanned.

2.4.2 Using the auto document feeder

1

Insert the document (up to 20 pages) FACE UP into
the feeder until a single beep is heard.

2

Adjust the width of the document guides (

1) to fit

the actual size of the document.

Note:

L

Confirm that there are no documents on the scanner
glass.

L

Check that ink, paste or correction fluid has dried
completely.

L

Remove clips, staples or other fasteners.

L

Do not set the following types of documents: (Make a
copy of the document using the scanner glass and
set the copy instead.)

Chemically treated paper such as carbon or
carbonless duplicating paper

Electrostatically charged paper

Badly curled, creased or torn paper

Paper with a coated surface

Paper with printing on the opposite side that can
be seen through the other side, such as
newsprint

L

The total height of the documents when laid flat,
must be less than 4 mm (

5

/

32

"). If the documents

exceed the capacity of the auto document feeder,
they may fall or cause a jam in the feeder.

L

To set a document with a width of less than 210 mm
(8

1

/

4

"), we recommend using the scanner glass to

copy the original document onto A4 or letter-sized
paper, then setting the copied document.

L

Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.

L

Available document size, document weight and
effective scanning area are as follows:

1

2

208 mm

(8

3

/

16

")

287 mm
(11

5

/

16

")

5 mm
(

3

/

16

")

5 mm
(

3

/

16

")

4 mm
(

5

/

32

")

4 mm
(

5

/

32

")

1

MB271-781-PFQX2722ZA-OI-en.book Page 17 Tuesday, May 22, 2007 5:20 PM

Advertising