Panasonic PT 60LCX64 - Manual (Page 37)

37
Basic Operation
The input mode changes each time this
button is pressed.
Video 1 Signal of source connected to INPUT 1 is displayed.
Video 2 Signal of source connected to INPUT 2 is displayed.
Video 3 Signal of source connected to INPUT 3 is displayed.
Comp 1 Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed.
Comp 2 Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed.
Comp 3 Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed.
RGB 1 Signal of source connected to RGB IN 1 is displayed.
RGB 2 Signal of source connected to RGB IN 2 is displayed.
HDMI Signal of source connected to HDMI IN is displayed.
Video 1* 1
Video 2* 1
Video 3* 1 Comp 1* 1
HDMI* 1
RGB 2* 1
RGB 1* 1
Comp 3* 1
Comp 2* 1
Card input mode (Photo Viewer) is
selected.
The input source for picture signals can be changed by pressing TV/VIDEO, SD on the Remote
Control or TV/VIDEO on the unit.
Changing the input signal
Device display operation
* 1 If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 71.)
Remote Control
Device display Unit
Photo (Photo Viewer) Signal of source connected to CARD SLOT is displayed.
Or
Video 1* 2
Video 2* 2
Video 3* 2 Comp 1* 2
HDMI* 2
RGB 2* 2
RGB 1* 2
Comp 3* 2
Comp 2* 2
TV (Antenna A)
TV (Antenna B* 1 )
TV
* 2 If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 71.)
* 1 Changing input is only possible if Cable/
Antenna is set as the Input Set setting.