Polycom Instructor RP Version 1.0 - Manual (Page 20)

Setting Up the Polycom Instructor RP
14
To calibrate the touch screen for Camera 4:
1. On the Polycom remote control, press
Camera and select 4.
— If you have an integrated PC or a guest
laptop, you will see the video from the PC
or laptop as well as the whiteboard icon in
the upper right corner of the screen.
— If you do not have an integrated PC or a
guest laptop, you will see a blank
whiteboard except for the whiteboard
icon in the upper right corner of the
screen.
2. Pick up a pen from the SMART tray.
3. Press the Keyboard button on the
SMART tray to bring up the calibration
screen.
4. Use the pen to touch the center of the
crosshair on the upper left of the screen.
If the PIP appears on the screen, use the
remote control to turn it off because it can
hide the crosshairs.
5. Use the pen to touch the center of the
crosshair on the lower right of the screen.
6. Use the pen to touch the center of the
crosshair on the upper right of the screen.
7. Draw on the screen to check that the
calibration worked correctly.
8. Do one of the following:
— If you have an integrated PC or a guest
laptop, you will see a blank whiteboard
except for the whiteboard icon in the
upper right corner of the screen. Click the
whiteboard icon and then continue by
repeating steps 2 through 7.
— If you do not have an integrated PC or a
guest laptop, continue with the Install the
Software and Complete the Calibration
section on page 15.
CALIBRATE TOUCH SCREEN
TOUCH UPPER LEFT TARGET
CALIBRATE TOUCH SCREEN
TOUCH LOWER RIGHT TARGET
CALIBRATE TOUCH SCREEN
TOUCH UPPER RIGHT TARGET