Maintenance, Tractor, 5 star pattern blade (see fig. 20) – Poulan Pro PP16H36RB LAWN TRACTOR User Manual

Page 19: 6 star pattern blade (see fig. 21)

Advertising
background image

19

0222

3

MAINTENANCE

FIG.20

5 STAR PATTERN BLADE (See Fig. 20)

The center of this blade has a fi ve (5) star pattern. The bolt
that attaches this blade has nor mal Right Hand threads
that loosens by turn ing ( ) counterclockwise and tight ens
by turning ( ) clockwise.

6 STAR PATTERN BLADE (See Fig. 21)

The center of this blade has a 6 star pattern. The bolt at-
tach ing this blade has Left Hand threads that loosens by
turning ( ) clockwise and tight en by turning ( ) coun ter -
clock wise.

RH

BLADE BOLT
RIGHT HAND
THREADED

LOCK
WASHER

FLAT
WASHER

BLADE

MANDREL
ASSEMBLY

5 STAR PATTERN

5 STAR CENTER HOLE

TRAILING EDGE

FIG.19

6 STAR PATTERN
BLADE W/LEFT HAND
THREAD ED BOLT

5 STAR PATTERN
BLADE W/RIGHT
HAND THREAD ED
BOLT

TRACTOR

Always observe safety rules when per form ing any main-
te nance.

BRAKE OPERATION

If tractor requires more than fi ve (5) feet to stop at highest
speed in high est gear on a level, dry concrete or paved
surface, then brake must be checked and ad just ed. (See
“TO ADJUST BRAKE” in the Ser

vice and Ad just ments

section of this manual).

TIRES
• Maintain proper air pressure in all tires (See “PROD UCT

SPEC I FI CA TIONS” section of this man ual).

• Keep tires free of gasoline, oil, or insect control chemi-

cals which can harm rubber.

• Avoid stumps, stones, deep ruts, sharp objects and

other hazards that may cause tire damage.

NOTE: To seal tire punctures and pre vent fl at tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also pre vents tire dry rot and
corrosion.

OPERATOR PRESENCE SYS TEM AND REVERSE OP-
ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation sys tems
are work ing properly. If your tractor does not function as
described, repair the problem immediately.
• The engine should not start unless the brake pedal is

fully de pressed, and the attachment clutch con trol is
in the dis en gaged position.

CHECK OPERATOR PRESENCE SYSTEM
• When the engine is running, any attempt by the op er a tor

to leave the seat without fi rst setting the parking brake
should shut off the engine.

• When the engine is running and the at tach ment clutch

is engaged, any attempt by the operator to leave the
seat should shut off the engine.

• The attachment clutch should never operate unless

the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM
• When the engine is running with the ignition switch in

the engine "ON" position and the at tach ment clutch
engaged, any attempt by the operator to shift into
reverse should shut off the engine.

• When the engine is running with the ignition switch in

the ROS "ON" position and the at tach ment clutch en-
gaged, any attempt by the operator to shift into reverse
should NOT shut off the engine.

BLADE CARE (See Fig. 19)

For best results mower blades must be kept sharp. Re place
bent or damaged blades.

CAUTION: Use only a replacement blade
approved by the manufacturer of your
tractor. Using a blade not approved
by the manufacturer of your tractor is
hazardous, could damage your tractor
and void your warranty.

828

ROS "ON" POSITION

ENGINE "ON" POSITION
(NORMAL OPERATING)

Advertising