Panasonic BL-PA100KT - Manual (Page 7)

7
Introduction
Security information
1. With any network connection, security is a concern. This product provides
security to prevent unauthorised access to your network.
• Only terminals that are registered to the master adaptor can
communicate with the network.
• A terminal may be registered to the master only if the SETUP buttons
on the master and terminal are pressed within 5 seconds of each other.
2. Data sent and received over the HD-PLC network employs AES 128-bit
encryption, however we cannot guarantee that data will not be intercepted by
a third party.
3. For security, reset your adaptors (see page 14) in the following situations.
• If you are concerned that another adaptor may have been accidentally
registered to your master (for example, the adaptor of someone who
lives in the same apartment building as you), reset each of your
adaptors and register them again.
• If you discard an adaptor, give an adaptor to someone else to use, or
send an adaptor for servicing, reset the adaptor first.
• If you lose an adaptor, reset your remaining adaptors and register them
again.
Security notices for when sending an adaptor for
service
Please note the following when sending an adaptor for servicing.
• Reset the adaptor before sending it for servicing.
• After your master adaptor is serviced, you must register all your
terminals to the master again.
• After a terminal adaptor is serviced, you must register the terminal to the
master again.