PYLE Audio PLCDUSMP74 User Manual
Page 4
3
Follow this easy wiring diagram in order to enable you to install
the new or existing RADIO and SPEAKER wring system.
Be sure the unit is connected to a 12 volts battery with negative ground.
Good ground connections eliminate most electrical noise problem and
require tight with the metal vehicle chassis.remove plastic, paint or dust
for good electrical contact.
SPEAKER WIRING
The unit is only designed for the use with 4 speakers system, it can
only be connected with speakers rated in the load impedance range
from 4 to 8 ohms. Load impedance less than 4 ohms could damage
the unit.
Never combine (BRIDGE) the outputs for use with 2 speakers, and
Never ground any Negative speaker to the chassis ground.
CAR ANTENNA
CAR ANTENNA
ORANGE
RED
WHITE
YELLOW
BLACK
RED
LEFT FRONT
LEFT FRONT
RIGHT FRONT
RIGHT FRONT
LEFT REAR
LEFT REAR
RIGHT REAR
RIGHT REAR
Connect to control for antenna or remote control for amplifier.
Connect to battery or +12 volts of power source that is always live.
Connect to lgnition key switch.
Memor y+
Ground-
12V+
GREEN
GREEN/BLACK
GREY
GREY/BLACK
BROWN
BROWN/BLACK
BLUE
BLUE/BLACK
RCA LINE OUT
RCA LINE OUT
FUSE