Planet Technology WNRT-625 - Manual (Page 4)


Hardware Installation
1. Locate an optimum location for the WNRT-625.
The best place for your WNRT-625 is usually at the center of your
wireless network, with line of sight to all of your mobile stations.
2. Adjust the antennas of WNRT-625.
Try to adjust them to a position that can best cover your wireless
network. The antenna’s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WNRT-625 LAN port.
Connect one of the LAN ports on WNRT-625 to your LAN switch/hub
or a computer with a RJ-45 cable.
4. Connect RJ-45 cable to WNRT-625 WAN port.
Connect the supplied Ethernet cable to xDSL/Cable Modem and the
WAN port on WNRT-625.
5. Plug in power adapter and connect to power source.
After power on, WNRT-625 will start to operate.
Note
ONLY use the power adapter supplied with the WNRT-
625. Otherwise, the product may be damaged.
If you want to reset WNRT-625 to default settings,
press and hold the RST/WPS button over 30 seconds
and release. And then wait for WNRT-625 restart.
RST / WPS Button
This button has two functions:
To Clear All Data and restore the factory default values:
Press the RST (reset) button for longer than 30 seconds until the
LED of power flash, and then the router will reset itself to the factory
default settings.
(warning: your original configurations will be replaced with the factory
default settings)
To make Wi-Fi Protected Setup (WPS) simple and easier:
Press the WPS button (for less than 20 seconds), machine will start
WPS function to build connection between wireless network clients
and this wireless router.