PYLE Audio PSW501SF User Manual
Page 2
Hardware List: Actual parts appearance and the quantity may different
with illustrated.
Hardware List:
After determining the height of stand, follow the installation instructions in below
to install wall mount to different kinds of wall
Using a awl or nail to make where the nails are located, as shown as Fig.3b. Distance
between two nails for fixing wall mount must not less than 16 . Slide the plate into
position as required.(Fig.3c) Pre-drill these holes with a 5mm drill bit to at least
40mm in deep hole. Use wall mount as a template to mark the location of other three
holes and drill the same holes.
Fix the wall mount to the wall with 4 long bolts(H) and washers(J)
.
-wooden, brick, concrete and stone.
Please make sure these holes are level and eudipleural.
by Box wrench(5)
Wooden wall:
”
Wooden wall:
-2-
-7-
A-F
J
G
I
H
K
Fig 3b
Fig 3c
Brick, Concrete and Stone wall:
Using a awl or nail to make where the nails are located. Distance between two nails
for fixing wall mount must not less than 16 . Slide the plate into position as required.
(Fig.3c) Pre-drill these holes with a 10mm drill bit to at least 50mm in deep hole. Use
wall mount as a template to mark the location of other three holes and drill the same
holes. Please make sure these holes are level and eudipleural. Insert wall anchors(I)
into each of these holes. Attach the wall mount to the wall using 4 long bolts(H) and
washers(J) by Box wrench(5).
”
Brick, Concrete and Stone wall:
1
2
4
2
3
Fig 3d
Balance-adjusting
H
J
1
Using balance-adjusting system on the plate,
make sure whether wall plate is installed
balance. If not, then slide the wall plate let
pointer level in the center position.
Plate
4
4
H
I
J
K
4
4
Square washer
Long bolt
Wall anchor
Long bolt washer
Spacer
ID
Description
1
2
A
3
4
5
B
C
1
2
4
1
2
1
4
4
Wall mount
Bracket
M4
mm
×12
bolt
M4
mm
×16
bolt
M5×
mm
16
bolt
M6×16mm bolt
M5×36mm bolt
M6×36mm bolt
Qty
D
4
4
4
4
E
F
G
Cable Cover
Safe bolt
Box wrench
ID
Description
Qty
5
5