ProForm 831.21002 - Manual (Page 11)

USING THE CONSOLE
Refer to the console diagram above. The function of
each console control is explained below:
Temperature: Controls the temperature of the water.
The water heats at about 2.0¡F an hour with the cover
on. The thermostat can be set to heat the water from
70¡F to 104¡F. Always use an accurate thermometer
to check the temperature of the water.
Jets: Turns the thera-jets on and off. To turn the
thera-jets on, press the control once. To turn the
thera-jets off, press the control twice. After you press
it once, the thera-jets will shut off for about 30 min-
utes, and restart. Press the control again. The thera-
jets will remain off. However, at any time after the
thera-jets have been shut off, the pump will begin
cycling to heat the water if the temperature falls below
the minimum setting. Note: To keep the heat cycle
from running, the power cord must be unplugged.
Air Control: Determines the amount of air that is in
the spa jet system during operation. If the control is
turned to the left, the amount of air flowing through
the jets will increase. If the control is turned to the
right, the amount will decrease.
Heat On: This LED indicator is lit when the spa is run-
ning the heating cycle. Note: To suspend the heat-
ing cycle, press the On/Off button once. The heat-
ing cycle and massage jets will shut off, and will
resume operation 30 minutes later.
Caution High Temp: This LED indicator will light if
the water temperature exceeds 120¡F. Do not enter
the spa. Add cold water to reduce water tempera-
ture. You must unplug the power cord, and plug it
back in to reset the spa; the spa will not operate
until it has been reset. If the spa repeatedly over-
heats, have it serviced by a qualified technician.
Refer to the diagram above. The function of each spa
jet is explained below:
The three uni-directional thera-jets (A), located on
one end of the spa, focus the water massage on your
back.
The three multi-directional thera-jets (B) can be
adjusted for a custom hydro-massage. One of the jets
is located below the three uni-directional thera-jets
and focuses the water massage on your lower back.
Another jet, located near the floor, focuses the water
massage on your legs. The remaining jet, located on
the other end of the spa, focuses the water massage
on your upper or lower back.
The filter (C) can be removed for replacement and
cleaning (see CHECKING AND CLEANING THE FIL-
TER on page 13 for information on how to remove the
filter from the spa).
.
The suction vent (D), located near the floor of the
spa, brings the water into the pump, in order to oper-
ate the system. The suction cover should always be in
place over the suction vent. Never operate the spa
without the suction cover in place.
This spa is ozone ready. An optional ozone generator
can be installed to utilize the ozone jet (E). Ozone
provides a way to help sanitize your spa with minimal
chemical treatment.
The RESTORATION 2.0 features automatic freeze
protection. If the water temperature falls below 40¡F,
the pump will begin circulating and heating the water
to prevent the water from freezing.
A
B
B
D
C
E
SPA JET OPERATION
11