Paxar Monarch 9805 - Manual (Page 16)

Error Description
758 Either the supply is not seen or the on-demand sensor is
broken. Check for a label jam, clear the supply path, or reload
supplies. This error may occur if you remove a label too
quickly in on-demand mode. The printer does not recalibrate
after this error.
763 Waiting to dispense label. Press Feed.
765 The printhead has less than four bad dots. The printer can
shift bar code fields to avoid bad dots. Press Clear to
continue printing. Print a test label to confirm the number of
bad dots.
768 Printhead has more than 10 bad dots or is not connected.
Connect the printhead.
791 The printer has an error pending. Turn off the printer. Wait 15
seconds (until the power light is completely dim) and turn it
back on. Resend the packets.
Check with your System Administrator for any message not listed.
P r i n t e r S p e c i f i c a t i o n s
Height: 13 inches (330 mm)
Width: 12 inches (305 mm)
Depth: 13 inches (330 mm)
Weight: 26 lb. (12 kg)
Shipping Weight: 30 lb. (13.6 kg)
Printhead: Thermal at 4 inches (102 mm) wide
203 dpi (8.0 dots per mm)
Printing Method: Thermal Transfer (ribbon) or Thermal Direct
Maximum Image
Size: 4.0 inches (102 mm) by 6.0 inches (152 mm)
Power: 115 VAC, 60Hz, 100 VAC, 50/60 Hz, 230 VAC, 50
Hz (Switching power supply)
Operating Limits: For Thermal Transfer (ribbon) 40
°
to 95
°
F
(4
°
to 35
°
C)
14