Patton electronic 1004S - Manual (Page 7)

RJ-45 Cable (4-Wire)
SIGNAL PIN# PIN# SIGNAL
GND † 2-----------------------7 GND †
RCV- 3-----------------------5 XMT-
XMT+ 4-----------------------6 RCV+
XMT- 5-----------------------3 RCV-
RCV+ 6-----------------------4 XMT+
GND † 7-----------------------2 GND †
RJ-11 Cable (2-Wire)
SIGNAL PIN# PIN# SIGNAL
XMT+ 3-----------------------3 XMT+
XMT- 4-----------------------4 XMT-
RJ-45 Cable (2-Wire)
SIGNAL PIN# PIN# SIGNAL
XMT+ 4-----------------------4 XMT+
XMT- 5-----------------------5 XMT-
† Connection to ground is optional
4.2 WIRING FOR MULTIPOINT CIRCUITS
The Model 1004 supports multi-point applications using either a
star or daisy chain topology. Both topologies require special wiring, as
well as specific DIP switch settings for master and slave units. Note:
Refer to Section 3.2.2 for multipoint DIP switch settings.
4.2.1 STAR TOPOLOGY
Using a star topology, you may connect several Model 1004s
together in a master/slave arrangement. Maximum distance between
the units will vary based upon the number of drops, data rate, wire
gauge, etc. Call Technical Support for specific distance estimates.
12
4.1.2 TWISTED PAIR CONNECTION USING RJ-11 OR RJ-45
The RJ-11 and RJ-45 connectors on the Model 1004’s twisted pair
interface are pre-wired for a standard TELCO wiring environment. The
signal/pin relationships are shown below:
RJ-11 SIGNAL RJ-45 SIGNAL
1 ...................GND † 1 ...................N/C
2 ...................RCV- 2 ...................GND
3 ...................XMT+ 3 ...................RCV-
4 ...................XMT- 4 ...................XMT+
5 ...................RCV+ 5 ...................XMT-
6 ...................GND 6 ...................RCV+
7 ...................GND
8 ...................N/C
† Connection to ground is optional
AT&T standard modular color codes
When connecting two Model 1004’s, it is necessary to use a
crossover cable. The diagrams below show how a crossover cable
should be constructed for the following environments: 4-wire RJ-11,
4-wire RJ-45, 2-wire RJ-11 or 2-wire RJ-45.
RJ-11 Cable (4-Wire)
SIGNAL PIN# PIN# SIGNAL
GND † 1-----------------------6 GND †
RCV- 2-----------------------4 XMT-
XMT+ 3-----------------------5 RCV+
XMT- 4-----------------------2 RCV-
RCV+ 5-----------------------3 XMT+
GND † 6-----------------------1 GND †
† Connection to ground is optional
11
1
2
3
4
5
6
7
8
1
2
3
4
5
6