PYLE Audio PICD65I - Manual (Page 5)

OPERATION WITH THE iPod/ iPhone
- TURN ON BOTH THE UNIT AND THE iPod/ iPhone.
- PRESS THE
KEY REPEATEDLY UNTIL THE DISPLAY SHOWS “iPod”
OR SIMPLY PRESS THE "DOCK" KEY ON REMOTE CONTROL.
- THE UNIT WILL AUTOMATICALLY START PLAYBACK OF THE SONGS.
- THE iPod
DISPLAY WILL INDICATE THE INFORMATION OF THE CURRENT
SONG (TRACK).
/ iPhone
- AT ANYTIME DURING PLAYBACK, PRESS THE KEY
TO PAUSE OPERATION OF THE UNIT. PRESS KEY TO RESUME
OPERATION AT THE SAME TRACK & POSITION.
- AT ANYTIME DURING PLAYBACK, PRESS & HOLD THE KEY
TO STOP PLAYBACK OF UNIT.
- AT ANYTIME DURING PLAYBACK, PRESS AND RELEASE THE
KEYS ON UNIT (OR "iPod NEXT/ iPod BACK" KEY ON REMOTE
CONTROL) TO SKIP FORWARD OR BACKWARDS BY ONE TRACK, AS DESIRED.
PLAY/PAUSE
PLAY/PAUSE
PLAY/PAUSE
- ANY ANYTIME DURING PLAYBACK, PRESS AND HOLD THE
KEYS ON UNIT (OR "iPod NEXT/ iPod BACK" KEY ON REMOTE
CONTROL) TO FAST-FORWARD (CUE) OR FAST-REVERSE (REVIEW)
THE SPECIFIC TRACK, WHICH IS CURRENTLY PLAYING.
- YOU CAN OPERATE THE iPod USING EITHER THE SET, REMOTE CONTROL
OR DIRECTLY WITH THE iPod ITSELF.
- WHEN THE iPod HAS BEEN CONNECTED WITH THE UNIT, IT WILL START
CHARGING THE BATTERY OF THE iPod .
/ iPhone
/ iPhone
/ iPhone
/ iPhone
- NEVER REMOVE (OR UNPLUG) THE iPod/ iPhone FROM THE SET DURING PLAYBACK,
ALWAYS PRESS & HOLD FOR 2 SECONDS THE KEY FIRST AND THEN
PRESS THE KEY TO SWITCH TO ANOTHER SOURCE (EG. “RADIO”
OR “AUX”) BEFORE REMOVING OR UNPLUGGING THE iPod/ iPhone,
TO PREVENT DAMAGE TO YOUR SONG FILES OR MEMORY DEVICES.
FUNCTION
PLAY/PAUSE
FUNCTION
3D-VIRTUAL SURROUND
REPEAT PLAYBACK FUNCTION (iPod/ iPhone)
- AT ANYTIME DURING iPod/ iPhone PLAYBACK:
- PRESS THE "PLAY MODE" KEY ON REMOTE CONTROL OR
PRESS THE FOLLOWING SYMBOLS ON THE iPod/ iPhone SCREEN:
= TO REPEAT THE CURRENT TRACK
= TO REPEAT ALL TRACKS
THIS UNIT IS DESIGNED TO ALLOW YOU TO CONNECT AN WITHOUT THE
NEED FOR DOCK CONNECTORS. THE DESIGN OF THE UNIT HAS BEEN STRUCTURED
TO PROVIDE SUPPORT TO TE CONNECTOR UNDER NORMAL USAGE WITHOUT EXCESSIVE
PRESSURE ON THE
WHEN CONTROLLING PLAYBACK USING THE
SCREEN.
iPod/ iPhone
iPod/ iPhone iPod/ iPhone
"Made for iPod," "Made for iPhone," mean that an electronic accessory has
been designed to connect specifically to iPod, iPhone, respectively, and has been certified
by the developer to meet Apple performance standards. Apple is not responsible for the operation
of this device or its compliance with safety and regulatory standards. Please note that the use
of this accessory with iPod, iPhone may affect wireless performance.
OR
BACK/ TUNE -
NEXT/ TUNE +
OR
BACK/ TUNE -
NEXT/ TUNE +
E-9 E-10
ELECTRONIC VOLUME CONTROL
- THIS UNIT USES AN ELECTRONIC VOLUME CONTROL .
- TO INCREASE OR DECREASE THE LOUDNESS OF UNIT, PRESS
THE VOLUME UP (VOL +) OR VOLUME DOWN (VOL -) KEYS RESPECTIVELY.
- RELEASE THE KEY WHEN VOLUME LEVEL IS AT THE DESIRED LOUDNESS.
- SOMETIMES, ESPECIALLY DURING LISTENING TO THE RADIO, YOU MAY NOTICE
A "CLICK-CLICK-CLICK" (REPEATING) SOUND WHEN YOU ARE INCREASING OR
DECREASING THE VOLUME. THIS IS A NORMAL CONDITION & THE SOUND WILL
DISAPPEAR WHEN YOU RELEASE THE VOLUME KEY (WHEN YOU REACH THE
DESIRED VOLUME LEVEL).
(PUSH BUTTON TYPE)
OPERATION OF RADIO
- PRESS THE "ON/OFF" KEY ONCE TO SWITCH ON THE UNIT.
- PRESS THE
KEY (ON UNIT) REPEATEDLY UNTIL THE DISPLAY
SHOWS "FM" .
- TO IMPROVE FM-RADIO RECEPTION, FULLY EXTEND THE FM-ANTENNA WIRE
AND ADJUST IT'S POSITION.
- USE THE "FM MODE" KEY (ON REMOTE CONTROL) TO SELECT THE
DESIRED MODE ( . IN SOME CASES, WHERE RECEPTION IS
POOR, IT MAY BE ADVISABLE TO SELECT “MONO” MODE, TO IMPROVE CLARITY
OF THE RADIO SIGNAL.
OR PRESS THE "TUNER" KEY ONCE ON REMOTE CONTROL
FM MONO/STEREO)
MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)
- PRESS (AND IMMEDIATELY RELEASE) THE KEY OR
KEY TO “SCAN” (MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
BY 1-STEP AT A TIME.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH
STEP’S POSITION.
- WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED
INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
NEXT BACK
AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)
- PRESS AND HOLD (FOR 2 SECONDS) THE OR KEYS
TO “SEEK” (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
TO THE NEXT AVAILABLE RADIO STATION.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE
NEXT STATION THAT IS FOUND.
- WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE
“MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
NEXT BACK
FUNCTION
RADIO MEMORY (STATION PRESET MEMORY STORAGE)
- AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE
STORED INTO ONE OF THE MEMORY POSITION.
- PRESS KEY ONCE.
- PRESS OR KEY ON THE REMOTE CONTROL TO SELECT
DESIRED MEMORY POSITION. (THERE ARE 30 MEMORY POSITIONS FOR FM BAND).
- PRESS KEY ONCE TO SAVE THE SELECTED STATION INTO THE
SELECTED MEMORY POSITION.
- TO RECALL ANY SAVED MEMORY, SIMPLY PRESS ,
THE SAVED RADIO-BAND WILL BE RECALLED.
- TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO
THE SAME MEMORY POSITION.
OR
PROGRAM
RADIO M+
PROGRAM
RADIO M-
RADIO M+ RADIO M-