Philips CD440 - Manual (Page 12)

Getting started 10
Connect the other end of the line cord to
the telephone line socket and the other end
of the power cable to the electricity socket
Note
The line adaptor may not be attached to the
line cord. In this case, you have to connect the
line adaptor to the line cord first before
plugging the line cord to the line socket.
3.2 Install rechargeable batteries
Your CD440 is supplied with two rechargeable
batteries. Before using the handset, install the
batteries into the handset and fully charge them
up.
Slide out the battery cover
Place the batteries as indicated in the
battery compartment and replace the
battery cover
3.3 Place the handset on the charging
cradle
When the battery is fully charged, the talk time
of your phone is approximately 12 hours and
the standby time is approximately 150 hours.
Place the handset on the charging cradle of
the base station
Leave it there until the batteries are fully
charged
2
1
2
1
3
3 Getting started
3.1 Connect the base station
Caution
Avoid placing the base station too close to
large metal objects such as filing cabinets,
radiators or electrical appliances. This can
impair the range and sound quality. Buildings
with thick internal and external walls may
impair transmission of signals to and from the
base.
Warning
Power is applied when the power adaptor is
plugged into the unit and connected to the
electricity socket. The only way to power down
the unit is to unplug the power adaptor from
the electricity socket. Therefore, ensure that
the electricity socket is easily accessible.
The power adaptor and the telephone line cord
have to be connected correctly, as incorrect
connection could damage the unit.
Always use the telephone line cord supplied
with the unit. Otherwise, you may not get a dial
tone.
Insert the plug of the power cord into the
socket under the base station
Insert the plug of the line cord into the
socket under the base station 2
1
!