PAR Technologies PARASTATION5 V5 User Manual
Page 53
ParaStation5 Administrator's Guide
49
If
nodes
is empty, the node range preselected via the range command is used. The default preselected
node range contains all nodes of the ParaStation cluster.
The
from
and
to
parts of each range are node IDs. They might be given in decimal or hexadecimal notation
and must be in the range between
0
and
NumberOfNodes-1
.
As an extension
nodes
might also be a hostname that can be resolved into a valid ParaStation ID.
Using hostnames containing "-" might confuse this algorithm and is therefore not
recommended.
exit
Exit the interactive mode of psiadmin. Same as quit.
help [
directive
]
Print a help message concerning
directive
. If
directive
is missing, a general help message is
displayed.
kill [
-sig
]
tid
Send the process with the task ID
tid
the signal
sig
.
sig
has to be a positive number representing a UNIX signal. For a list of available signals please consult
the signal(7) manual page. If
sig
is not given, a SIGTERM signal (i.e. 15) is sent to the corresponding
process.
Processes can only be signaled by their owner or by root.
list [ all | allproc [cnt
count
] | count [hw
hw
] | down | hardware | load | mcast | memory | node | proc [cnt
count
] | rdp | summary [max
max
] | up | version ] [
nodes
]
list jobs [ state running | state pending | state suspended ] slots [
tid
]
Report various states of the selected node(s) or job(s). Depending on the given argument, different
information can be requested from the ParaStation system. If no argument is given, the
node
information is retrieved.
all
Show the information given by node, count and proc on the selected node(s).
allproc [cnt
count
]
Show all processes managed by the ParaStation system on the selected node(s).
All processes - including forwarder and other special processes - managed by ParaStation are
displayed. If forwarder processes should not be displayed, use the list
proc
directive.
Up to
count
processes per node are displayed. If more processes are controlled by ParaStation
on this node, a short remark will tell the number of not displayed processes. The default is to show
10 processes.
The output fields of the process list are described within the list
proc
directive. In addition to the
process classes described there, ParaStation Forwarder processes, i.e. processes spawned by
the ParaStation daemon psid(8) in order to control a spawned process, are marked by “(F)” after
the user ID. Further helper processes needed in order to spawn non ParaStation applications are
marked with “(S)”.