Parasound Halo T 3 - Manual (Page 11)

TRIGGERING ANOTHER COMPONENT FROM THE T 3’S 12V
LOOP OUTPUT JACK
The T 3 12V Trigger Loop Out jack loops through the same +12 Vdc voltage received at its 12V
Trigger Input jack. This makes it convenient to control another component such as a Parasound
power amplifier.
What You’ll Need:
• A second trigger cable with 2.5 mm sub-mini plugs
• A component that can be triggered with an external +9 Vdc
to +12 Vdc trigger voltage
Before Connecting
Remove power to all the components in your audio system.
To Connect
Connect one end of this cable to the 12V Loop Out jack on the T 3.
Connect the other end to the component you want to trigger.
8
1
2
YOU SHOULD KNOW
If the component you want your T 3 to control doesn't have a 2.5 mm trigger output
connector, you can cut one plug off the cable and modify the end as needed. The wire with
the red stripe is positive and the wire without the stripe is negative.
2.5 mm sub-mini plug
RS232 Control Region
EU US
Input
2
1
TRIGGERED UNIT