PSC PowerScanTM RF - Manual (Page 12)

User’s Guide 9
Four Station Charger
If you have a Four Station Charger, batteries are inserted for charging
as shown in Figure 5. A 90% rapid charge can be achieved in only two
hours when using this optional accessory, half the time than when a
Base Station is used for charging. The LEDs at each battery station
operate the same as the CHARGE LED on the Base Station, with
rapid flashing indicating that rapid charging is taking place and on
steady during trickle charging or when the rapid charge cycle is fin-
ished.
Figure 5. Using the Four Station Charger Accessory
NOTE
If you insert a battery into the Four Station Charger
and no LEDs illuminate, the battery may be too
cold. Batteries must be at 0°C or higher to charge.
Do not attempt to charge cold batteries, since plac-
ing them in the charger will curtail the charging of
other batteries already present in the unit.
1. Device Power LED 2. Station Charge LEDs
1
2