Pressure washer terminology, Pressure washer operating features – Porter-Cable A09608-0412-0 User Manual

Page 10

Advertising
background image

10- ENG

A09608

PRESSURE WASHER

TERMINOLOGY

PSI: Pounds per Square Inch. The

unit of measure for water pressure.

Also used for air pressure, hydraulic

pressure, etc.
GPM: Gallons Per Minute. The unit of

measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied

by PSI. GPM x PSI = CU
Bypass Mode: Allows water to

re-circulate within pump when the

gun trigger is not pulled.

Allowing the unit to

run for more than

two minutes without the gun trigger

pulled could cause overheating and

damage to the pump.
Thermal Relief

Valve: When the

temperature inside

the pump rises too

high the valve will

open and release a

gush of water in an

effort to lower the

temperature inside the pump. The

valve will then close.
Chemical Injection System: Mixes

cleaners or cleaning solvents with

the water to improve cleaning

effectiveness.
Water Supply: All pressure washers

must have a source of water. The

minimum requirements for a water

supply are 20 PSI and 5 gallons per

minute.

PRESSURE WASHER

OPERATING FEATURES

PRESSURE ADJUSTMENTS

The pressure setting is preset at the

factory to achieve optimum pressure

and cleaning. If you need to lower the

pressure, it can be accomplished by

these methods.
1. Back away from the surface

to be cleaned. The further away

you are, the less the pressure will

be on the surface to be cleaned.

2. Change to the 40º nozzle -

(white) this nozzle delivers a less

powerful stream of water and a

wider spray pattern.

DO NOT attempt

to increase pump

pressure. A higher pressure setting

than the factory set pressure may

damage pump.
3. Adjust the

pressure reg-

ulator on the

pump. Turn

the pressure

regulator knob

counterclock-

wise to lower

pressure. Re-

fer to the illustrations to identify

your pressure regulator. Once

you have finished using your pres-

sure washer, return the pressure

regulator to its original position

by turning it clockwise.

DO NOT try to turn

pressure regulator

knob past the built-in stop or

damage to pump will result.

Thermal

Relief

Valve

Pressure

Regulator

Knob

Advertising
This manual is related to the following products: