Panasonic WJ-SX 150 - Manual (Page 112)

116
WJ-HD500 SERIES CONTROL (TERMINAL MODE)
Matrix switcher can control Digital Disk Recorder WJ-
HD500 Series. The following is the procedure of WJ-HD500
Series SETUP MENU.
Notes:
• The following operating procedures are for the terminal
mode. If you are using a PS·Data system controller,
refer to p. 124.
• When a Multiplexer board is installed in the unit, you
can neither connect nor control a WJ-HD500 Series
recorder. You need to remove the board from the unit.
■ Displaying WJ-HD500 Series SETUP
MENU
To display WJ-HD500 Series SETUP MENU, follow the pro-
cedure below.
1. Confirm that WJ-HD500 Series is correctly and securely
connected.
2. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
The monitor number and camera number will appear on
the LED display.
3. Press the RECORDER button.
The system will enter the recorder mode and the select-
ed monitor will change into multiscreen display. Then,
the selected monitor number and "-H00" will appear on
the LED display
4. Press the SETUP button while holding down the SHIFT
button on the system controller.
WJ-HD500 Series SETUP MENU will appear on the
active monitor and the system controller's SETUP indi-
cator will light up.
The following functions and buttons are valid in SETUP
MENU.
Joystick to UP ( ▲ ): Moves the cursor up.
Joystick to DOWN ( ▼ ): Moves the cursor down.
Joystick to L ( t ): Moves the cursor to the left.
Joystick to R ( s ): Moves the cursor to the right.
CAM (SET) button: Executes the selections and dis-
plays a submenu.
NEXT button: Increments a parameter.
PREV button: Decrements a parameter.
MON (ESC) button: Returns to SETUP MENU or the
previous menu.
5. To end the setting and return to the normal view, press
the SETUP button while holding down the SHIFT button
when SETUP MENU is displayed. The system con-
troller's SETUP indicator will go out.
■ Controlling Digital Disk Recorder WJ-
HD500 Series
The following are the operating procedures of WJ-HD500
Series via system controller.
Note: Refer to the operating instructions of Digital Disk
Recorder WJ-HD500 Series for details.
● Recorder Mode
Before operating the recorder, it is necessary to enter the
recorder mode.
1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
The monitor number and camera number will appear on
the LED display.
2. Press the RECORDER button to enter the recorder
mode.
SETUP SHIFT
REW/FF
STEP
CALL
PRESET
PROGRAM
PRESET
GROUP SEQ
PAUSE
SUSPEND
F1
CAM SETUP ALL RESET
ACK RESET
F2 TOUR SEQ
PREV NEXT
STOP
OSD
AUTO PAN
RECORDER
INDEX
STOP PLAY PAUSE
CAM FUNC
CLEAR
LOG OUT MON LOCK
DEF ON
WIPER
DEF OFF
MON (ESC)
T&D CAM ID
MON STATUS ALL
EVENT
ALM H VLD H SYS S
CAM (SET)
MULTI SCREEN SEL
SEQUENCE
AUX2 ON AUX2 OFF EL-ZOOM
AUX1 ON AUX1 OFF STILL
UP
L R
DOWN