Power Acoustik PTID-3600 - Manual (Page 24)

Page - 23
Note on Discs
— Only use groundless loudspeakers.
— Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loud
speakers at higher volumes.
— Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may
damage the unit.
— Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body.
— (GND). using a BTL circuit and each loudspeaker must be connected with insulated cables
according the diagram.
— Loudspeaker cables and/or optional external power amplifiers must always be about 30cm.
away from the antenna and/or antenna extension parts.
— If want to display for 3.6” TFT, parking wire must be connected to ground.