Phase Technology SM500i - Manual (Page 3)

Technical data, EASE ™ plots, SoundTubeSPEC ™ software & product downloads available at www.soundtube.com
SM500i Surface-Mount Speaker
Technical Information for System Engineers
proprietary captured ball mount-
ing system with security screw for
theft prevention. The full frequency
dispersion pattern (45 Hz – 10 kHz,
EASE ™ documented) and high sensitiv-
ity (88.5 dB 1W/1M) make the SM500i
surface-mount speaker ideal for music
& paging in retail, amusement, restau-
rant, airports, hotels, schools and casi-
nos. For applications where additional
bass is required, SoundTube’s RS801i
subwoofer provides bass down to 40 Hz.
BroadBeam ® Wide
Dispersion Technology
More than 3 years in development,
SoundTube’s proprietary BroadBeam ®
technology incorporates a high-fre-
quency waveguide mated to a 1” convex
metal tweeter. BroadBeam ® wave-
guide technology delivers a consistent
BroadBeam ® dispersion pattern across
the upper registers of the frequency
spectrum (up to 10 kHz, EASE ™ docu-
mented). The result is an audio system
with fewer speakers, reduced power
needs, shorter installation time and cost
savings on shipping & labor.
Patented SoundTube
Technologies
SoundTube Entertainment is constantly
developing new technologies that enhance
audio product performance. SoundTube
Entertainment innovations are protected
by multiple U.S. & international patents,
which explicitly cover SoundTube dome,
enclosure and dispersion technologies.
SoundTube Entertainment actively
defends its patents in order to protect
SoundTube resellers and end users.
Technical Data and
Specification Tools
Technical Data
SoundTube Entertainment strives to
provide complete and effective technical
information and data to dealers, engineers
and designers. All data are available
from SoundTube Entertainment or at
www.soundtube.com.
Data Acquisition
All performance data acquired at
SoundTube’s Technical Measurement Cen-
ter (TMC) are analyzed using a variety
of standard measurement techniques,
including Measured Length Sequence
(MLS) and Time Delay Spectrometry
(TDS). Performance, development and
data acquisition tools include: Gold Line
TEF 20, CLIO, LMS, LEAP, and propri-
etary modeling software. EASE™ data
are acquired through an automated TEF
20/Outline/EASE ™ interface.
EASE™ Data – 3-D polar plots.
SoundTubeSPEC™ – Proprietary
SoundTube speaker placement software.
Architectural Specifications
The loudspeaker shall consist of a 133
mm (5.25 in) low-frequency transducer
and a 25 mm (1.0 in) high-frequency trans-
ducer with a frequency-dividing network
installed in the vented enclosure. The
low-frequency voice coil diameter shall be
25 mm (1.0 in).
Performance specifications of a typical
production unit shall be as follows: Use-
able frequency response shall extend from
45 Hz – 22 kHz (-10 dB, half space, no
external equalization). Measured sensitiv-
ity (2.83 Volt input, 1 meter) shall be at
least 88.5 dB. The speaker shall have a
10,000 Hz 8,000 Hz 4,000 Hz 2,000 Hz
1,000 Hz 500 Hz 250 Hz 125 Hz
Polar Plots
Horizontal
Vertical