PS Audio TRIO C-100 - Manual (Page 9)

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
Questions and Answers 5
® Questions And Answers
Owner’s Reference P-200 Preamplifi er C-100 Control Amplifi er
©2006 PS Audio International Inc. All rights reserved.
You can power nearly every loudspeaker made with a C-100. It is relatively tolerant of most loudspeakers
loads and will not be damaged by attempting to power heavy loads. If, while playing music, the C-100
continues to go into a protection mode when the music gets loud, it means that the speaker load is
probably too diffi cult for the
C-100.
The Trio is specifi c to your
country’s voltage. Do not
use the Trio on a voltage
higher than it is rated for. For
instance, do not take a 120
volt rated Trio and attempt to
use it in a 230 volt country.
Failure to observe this
cautionary note will void your
warranty and may damage
the amplifi er. If you need to
operate the Trio at a voltage
other than the voltage it was
designed for, contact your
dealer, distributor or the
factory.
If the C-100 protection circuitry is activated, the amplifi er will immediately shut off. You need to switch
off the rear power switch and then turn it back on to reset the amplifi er’s protection circuitry.
The Trio produces little heat under normal operation so ventilation requirements are typically minimal,
but there needs to be some measure of airfl ow for proper opreation.
Protection circuitry
What voltages
can the Trio run
on?
Does the amp
require ventilation?
What speakers can
I use?