Panasonic SA-XR50 AV - Manual (Page 24)

RQT7487-P
H1203RF0
Panasonic Consumer Electronics
Company, Division of Matsushita
Electric Corporation of America
One Panasonic Way Secaucus,
New Jersey 07094
http://www.panasonic.com
Panasonic Sales Company,
Division of Matsushita Electric of
Puerto Rico, Inc. (“PSC”)
Ave. 65 de InfanterÍa, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985 Panasonic Canada Inc.
5770 Ambler Drive
Mississauga, Ontario
L4W 2T3
www.panasonic.ca
En
2003 Matsushita Electric Industrial Co., Ltd
Printed in Malaysia
Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart
do not solve the problem:
In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or the website (http://www.panasonic. com/contactinfo), or the
website (http://www.panasonic.com/support).
In Canada, contact the Panasonic Canada Inc. Customer Care Centre at 905-624-5505, or visit the website (www.panasonic.ca), or an
authorized Servicentre closest to you.
n Common problems Pages
n Sound modes Pages
n Radio Pages
n Multi control mode menus and factory settings
(Reference pages are shown as black circled numbers  )
No power. • Ensure the power cord is connected. 5
No sound.
• Turn the volume up.
• Check connections to speakers and other equipment.
• Turn on the speakers
• Turn off the tape monitor.
• Select the correct source.
• Change the D-INPUT setting to suit the type of connection you have made.
• Check that the digital signals can be decoded by this unit.
• Turn PCM FIX or DTS FIX off. 12
4-9
12
15
12
10
12
10, 18
Sound stops. “F 76” or
“OVERLOAD” appears on the
display for about a second, and
the unit turns off.
• Determine and correct the cause, then turn the unit on.
Causes include:
− Shorting (bare wires touching) of positive and negative speaker wires.
− Using speakers with an impedance lower than that rated for this unit.
− Straining of the speakers through excessive volume or power.
− Using the unit in a hot environment without proper ventilation.
Consult your dealer if the problem occurs again after switching the unit on.
5, 9
5, 9
–
–
“F 70” appears on the display. • Turn the unit off, disconnect the AC power supply cord, and consult your dealer. –
Sound is not heard from the center,
surround, or subwoofer speakers.
• Ensure the SPEAKERS settings for your speakers are correct.
• Turn 2CH MIX off.
• The source may be stereo. Change the sound mode. 10, 21
13
12
Sound is not heard from the
surround back speaker. • Ensure the SPEAKERS settings for your speakers are correct.
• Turn 6.1CH DECODING mode on. 10, 21
12
Cannot use Dolby Pro Logic Ⅱ ,
DTS NEO:6 or SFC.
• Turn DVD ANALOG 6CH off.
• You cannot use Dolby Pro Logic Ⅱ , DTS NEO:6 or SFC when input is PCM with sampling
frequencies of 192, 176.4 (COAXIAL1), 96, or 88.2 kHz.
15
13
There is no DTS audio output.
There is Audio output, but the DTS
decoder indicator is not lit.
• Check the DVD player’s digital output settings. –
The radio cannot be tuned in or
there is a lot of noise and
interference.
• Connect the appropriate antenna. (You may need an outdoor antenna or one with more elements.)
• Adjust the position of the FM or AM antenna.
• Reduce the treble.
• Turn off nearby televisions, video decks, DVD players, and satellite receivers.
• Separate the antenna from other cables, cords, and appliances. 9
9
19
–
–
Main menu Sub menu (factory settings) Main menu Sub menu (factory settings) Main menu Sub menu (factory settings)
TUNER
(TUNER
mode
only) TUNING MANUAL
 OPTION
B PROOF MODE A 
SETUP 2
SPEAKERS
FRONT
SMALL

FM MODE AUTO RESET YES  CENTER
MEMORY CH 1

SETUP 1
SPEAKERS
SUBW YES
LCR S SB

SURROUND
AUTO MEM START SUBW NO SUR BACK
YES
TONE
BASS
0dB

D-INPUT
TV OPT 1 SUB-WFR
TREBLE DVR OPT 2
DISTANCE
FRONT
10 FEET
BALANCE L R DVD COAX 1 CENTER
DIMMER
OFF

CD COAX 2 SURROUND
5 FEET
ON LEVEL 2
IN MODE
TV
AUTO
SUR BACK
SLEEP OFF DVR FILTER 100
OPTION
DUAL PRG MAIN

DVD EXIT á Exit the Multi control mode
DR COMP OFF CD
A/D ATT OFF