Pentek Water Dispenser - Manual (Page 4)

Scale & Coarse Sand, Dirt, Fine sand, Extra-fine sand,
rust particles sand silt dirt, silt dirt, silt
P5 5 micron nom. Spun Polypropylene 10 gpm/<1 psi 2 mo. • • • • •
CP-5 5 micron nom. Pleated Cellulose/Poly 10 gpm/< 1psi 2 mo. • • • • •
CW-F 10 micron nom. Cord-Wound 7 gpm/< 1 psi 3 mo. • • • •
S1 20 micron nom. Pleated Cellulose 10 gpm/< 1 psi 4 mo. • • •
CW-MF 30 micron nom. Cord-wound 10 gpm/< 1 psi 3 mo. • • •
R30 30 micron nom. Pleated polyester 12 gpm/< 1 psi 4 mo. • • •
R50 50 micron nom. Pleated polyester 12 gpm/< 1 psi 4 mo. • •
Troubleshooting
Leaks…Between cap and bottom of housing:
1. Turn off water supply and press the red pressure-relief button.
2. Clean and lubricate o-ring if necessary, then screw bottom of housing
onto cap and hand-tighten. DO NOT OVER-TIGHTEN.
4
Mfg. By Pentair Water Treatment ® 2003 145817 Rev B 10/03
WARRANTY
Pentek warrants to the original owner (under normal use): all products and parts to be free from defects in material and workmanship for a period of one (1) year. Notwithstanding the foregoing, (a) the warranty period for sumps shall be a period of five (5) years. Any
replacement products furnished will be free from defects in material and/or workmanship for the remainder of the original warranty period, or 30 days, whichever is longer. This warranty does not cover: (1) cartridges, media, and accessories (2) defects not reported
within the above time period, (3) items manufactured by other companies, (4) problems arising from failure to comply with Pentek instructions, (5) problems and/or damage arising from acts of nature, abuse, misuse, negligence or accident by any party other than Pentek,
(6) problems and/or damage resulting in whole or in part from alteration, modification, repair or attempted alteration, modification or repair by any party other than Pentek, (7) noncompliance with applicable codes/ordinances. If a defect in workmanship and/or material
in a product or part covered by the warranty should arise, Pentek, at its sole discretion, will repair or replace the defective product or part (Pentek may consider, in good faith, the customer's preference).
All claimed defective product must: (1) be authorized for return by Pentek with an RGA number (2) include proof of the purchase date of the product or part (3) returned to Pentek prior to the expiration of the warranty date, at the customer's expense, shipment pre-paid,
(4) be accompanied by a letter detailing the Model Number, Serial Number (if any), and a brief description of the problem. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, PENTEK DISCLAIMS ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH REGARD TO THE PRODUCTS, PARTS AND ANY ACCOMPANYING WRITTEN MATERIALS.
To the maximum extent permitted by applicable law, Pentek shall not be liable for any damages whatsoever (including, but not limited to, loss of time, inconvenience, expenses, labor or material charges incurred in connection with the removal or replacement of the
products or parts, special, incidental, consequential, or indirect damages for personal injury, loss of business profits, business interruption, loss of business information, or any other pecuniary loss) arising out of the use of or inability to use the defective products or parts,
even if Pentek has been advised of the possibility of such damages. Penteks' maximum liability under any provision of this Limited Warranty shall be limited to the amount actually paid for the products or parts. NOTE: Because some states do not allow the exclusion or
limitation of incidental or consequential damages, the above limitations or exclusions may not apply. THIS WARRANTY GRANTS SPECIFIC LEGAL RIGHTS, AND OTHER RIGHTS MAY APPLY. SUCH RIGHTS VARY FROM STATE TO STATE.
PENTEK FILTRATION
502 Indiana Avenue • Sheboygan, WI 53081
Toll Free Technical Support: 800-861-8758 • Technical Support: 920-451-9301 • [email protected]
Phone 920-457-9435 • www.pentekfiltration.com
International Fax: 920-457-2417 • [email protected]
Chlorine Bad Taste Sediment
Taste & Odor
C1 5 micron nom. Carbon-impregnated 5 gpm/2 psi 3 mo. • • •
Cellulose
CC-10 — Granular Activated Carbon 1 gpm/3 psi 6 mo. • •
(coconut-shell)
GAC-10 — Granular Activated Carbon 1 gpm/3 psi 6 mo. • •
CBC ® -10 .5 micron nom. Activated Carbon Block 1 gpm/< 2 psi 12 mo. • • •
Scale and Coarse Sand, dirt, Fine sand, Extra-fine sand,
Rust particles sand silt dirt, silt dirt, silt
CP5-BB 5 micron nom. Pleated Cellulose /Polyester 20 gpm/< 1 psi 3 mo. • • • • •
S1-BB 20 micron nom. Pleated Cellulose 20 gpm/< 1 psi 4 mo. • • •
R30-BB 30 micron nom. Pleated Polyester 25 gpm/< 1 psi 6 mo. • • •
R50-BB 50 micron nom. Pleated Polyester 25 gpm/< 1 psi 6 mo. • •
Chlorine Bad Taste Sediment
Taste & Odor & Odor
RFC-BB 25 micron nom. Granular Activated Carbon 10 gpm/1 psi 3 mo. • • •
On unit inlet/outlet connections:
1. Turn off water supply. Tighten compression fittings with a wrench.
DO NOT OVERTIGHTEN.
2. Turn on water supply. If leaks persist, or if there are other leaks on unit, turn off
water supply. Call Pentek Technical Support at 1-800-861-8758 .
Replacement Filter Cartridges
WHOLE HOUSE Sediment Cartridges
UNDERSINK DRINKING Water Cartridges
HEAVY-DUTY Cartridges
Model Filtration Filter Material / Max Flow Rate/ Filter
Rating Construction Pressure Drop Life*
Model Filtration Filter Material / Max Flow Rate/ Filter
Rating Construction Pressure Drop Life*
Model Filtration Filter Material / Max Flow Rate/ Filter
Rating Construction Pressure Drop Life*
Reduces:
Reduces:
Reduces:
* Filter life depends on usage
and water conditions.