Pyramid Car Audio PA600X - Manual (Page 5)

0 t
9 q w e r
4
9.Voltage Switch
The amplifier has selectable input voltage from 110V/60Hz which is the standard in USA and
CANADA. You can also switch the input voltage to 220V/50Hz for EUROPEAN operation. Please
make sure the switch is in the proper position before operating, otherwise severe damage will
result not cover by the warranty. Please also replace the fuse with proper rating in this situation
(see the SPECIFICATIONS for the fuse rating).
10.Switched AC Accessory Outlet (PA800X/PA1000X/PA1800X)
There is supplied AC OUTLET (SWITCHED MAX. 400W) which allow the electrical hook up of
other units.
11.Speaker Terminals
Permits hook up of two stereo pair of speakers via the wire terminals. You can choose either
Channel A , Channel B, or use both at the same time. Speaker impedance can range from 4
to 16 Ohms.
12.Fan Cooling (PA800X/PA1000X/PA1800X)
Cooling system is automatically activated whenever amplifier is turned on. This forced air cooling
system rapidly exhausts interior heat, reducing operating temperature and aiding performance.
13.Input Jacks
Let you connect a variety of audio input sources via the balanced 6.35mm phone jack or
unbalanced RCA inputs.
14.Stereo/Mono Switch (PA1000X/PA1800X)
Lets you select bridged mono input mode in combination with a mono signal source plugged
into the LEFT input channel, or conventional stereo operation with a stereo input signal.
15.Mono Bridged Output (PA1000X/PA1800X)
Connect the speaker's positive (+) to the amplifier's LEFT/RED (+) terminal and negative (-) to
the amplifeir's RIGHT/RED (+) terminal.
REAR PANEL - PA600X / PA800X / PA1000X / PA1800X
REAR PANEL - PA800X / PA1000X / PA1800X