Philips juice extractor serving pitcher HR2828 - Manual (Page 9)

5
4 When the flow of juice into the pitcher has stopped, turn the
appliance off by pressing the on/off (O) switch and WAIT
UNTIL THE SIEVE HAS COMPLETELY STOPPED ROTAT-
ING.
Do not fill the pitcher beyond the MAX indication to prevent juice
from being spilt. If you want to extract a large quantity of juice, empty
the reservoir at a certain point during the process.
Do not let the appliance run continuously for more than two minutes.
If you have not finished extracting juice, turn the appliance off by
pressing the on/off (O) switch and allow it to cool down for two min-
utes before you continue.
5 If the pulp container becomes full before you are finished,
turn the Juice Extractor off (O) and follow the directions
below to empty it.
C
6 Pour out the juice.
It is not necessary to disassemble the Juice Extractor.
If the pulp container is full:
1 Turn the appliance off by pressing the on/off (O) switch and
WAIT UNTIL THE SIEVE HAS STOPPED ROTATING
COMPLETELY.
2 Empty the pulp container.
3 Reassemble the Juice Extractor and continue.
. least 1˝ (3 cm) from heating elements. Cleaning
• Turn the appliance off by pressing on/off switch off (O) and unplug
the cord from the electrical outlet and WAIT UNTIL SIEVE HAS
COMPLETELY STOPPED ROTATING before you start cleaning
the appliance or removing parts.
• Do not use abrasive cleansers, scourers, wire wool, acetone,
alcohol, etc. to clean parts.
1 Remove the parts from the motor unit.
2 Clean the parts that have been in contact with food in
hot soapy water immediately after use and rinse them
with hot water. Dry all parts.
Do not put any of the parts in the dishwasher.