Panasonic UB-5838C - Manual (Page 21)

Scanning
21
Us
in
g
6 Press the Start/Stop Key.
• The unit starts scanning and the image is
printed.
• The copying status is shown on the display.
• After printing is finished, the Screen Erase
Announce will be shown on the display.
7 After erasing the written text/diagrams on the
screen, press the Mode Key (
) to return to
standby mode.
Note
• Only remove the USB cable once you have
returned to standby mode.
• For information regarding how to set ink
cartridges or paper in your printer, please
refer to the manual of the printer.
■ System Requirements
*1 This unit does not function with Hi-Speed USB 2.0. Even if
using a computer equipped with Hi-Speed USB 2.0, this unit
functions with Full Speed USB 2.0.
(This unit will not run at the rated speed of Hi-Speed
USB 2.0.)
*2 Microsoft
® Windows® 2000 operating system (hereafter
Windows 2000)
*3 Microsoft
® Windows® XP operating system
(hereafter Windows XP)
*4 Microsoft ® Windows Vista® operating system
(hereafter Windows Vista)
■ Scanning to a computer
1 Set the power switch to on ( I ).
2 Connect the computer to “USB Connector-B for
Computer” with a USB cable (included).
• The computer icon is shown on the display.
The display below is an example of the unit in
standby mode.
• The computer recognizes the electronic board
as a Removable Disk and the drive is
displayed in the Windows Explorer window.
Scanning to a computer
Computer IBM
® PC/AT® or compatible machine
Interface USB 2.0 or USB 1.1* 1
OS Windows ® 2000* 2
(Service Pack 4 or later)
Windows
® XP* 3
(Service Pack 2 or later)
Windows Vista
®* 4
Computer
UB5838C-PJQXC0259ZA_mst.book 21 ページ ２００９年５月２６日 火曜日 午後２時５９分