Promise Technology SuperSwap 4600 - Manual (Page 28)

SsuperSwap 4100 User Manual
22
Fan Replacement
To replace a fan on the SuperSwap 4600, do the following:
1. Power down the PC.
2. Remove the SuperSwap enclosure from the PC chassis.
3. Remove the two mounting screws on the fan.
4. Pull the fan from the two mounting pins and the wire away from the bracket.
Do not bend the bracket.
5. Unplug the power connector.
6. Plug the power connector of the new fan.
7. Lay the wire through the bracket and place the fan onto the two mounting
pins.
8. Install the two mounting screws.
9. Reinstall the SuperSwap enclosure into the PC chassis.
10. Power up the PC and check fan function.
Mounting Screw
Wire Bracket
Power Connector
Mounting Pin
Fan