Panasonic Blu-ray DiscTM Home Theater Sound System SC-BTT490 - Manual (Page 20)

20
VQT3X49
Inserting or removing
media
≥ When inserting a media item, ensure that it is
facing the right way up.
≥ When removing the SD card, press the center
of the card and pull it straight out.
≥ If you connect a Panasonic product with a USB
connection cable, the setup screen may be
displayed on the connected equipment. For
details, refer to the instructions for the
connected equipment.
≥ Use the front USB port when you connect a
USB memory or a USB HDD. The USB port on
the rear panel is only for the Communication
Camera.
Enjoying TV with unit’s
speakers
1
Connect the TV and the main unit.
( > 14-15)
2
Press [EXT-IN] several times to select the
appropriate external input mode. ( > 21)
≥ Reduce the volume on the TV to its
minimum, and then adjust the volume of the
main unit.
1
Press and hold [ jAUDIO] to activate the
audio setting mode.
2
Press [ jAUDIO] several times to select
the audio. (MAIN, SAP)
≥ Set “PCM-FIX” (> 37) to “Off”.
≥ “SAP” (Secondary Audio Program) only
works with Dolby Dual Mono.
≥ You cannot change the audio type when the TV is
connected to this unit via the AUX terminal.
SD CARD
VOL OPEN/CLOSE
Selecting the type of audio
SC-BTT490P_eng.book 20 ページ ２０１２年２月２２日 水曜日 午前９時１分