Panasonic Blu-ray DiscTM Home Theater Sound System SC-BTT490 - Manual (Page 40)

40
VQT3X49
∫ Unit Settings
Press [OK] to show the following settings:
¾Front Panel Display
Changes the brightness of the unit’s display.
≥ If “Auto” is selected, the display is set to bright
and only dimmed during playback.
¾Edit User Information
Change the user information registered in the
Home menu.
∫ Quick Start
Speed of startup from power off is increased.
≥ When set to “On”, the internal control unit will be
powered and the idle power consumption will
increase compared to when set to “Off”. (About
the power consumption
> 49)
∫ Remote Control Code
Change the remote control code if other
Panasonic products react to this remote control.
∫ Firmware Update (> 19)
Press [OK] to show the following settings:
¾Automatic Update Check
When this equipment remains connected to the Internet,
it will check for the latest firmware version when it is
turned on and you can update it if necessary.
¾Update Now
You can update the firmware manually if a
firmware update is available.
∫ System Information
Press [OK] to show the following settings:
¾License
Information about the software used by this unit
is displayed.
¾Firmware Version Information
Display firmware version of this unit and
wireless LAN module.
∫ Restore Default Settings
This returns all values in the Setup menu and the
Option menu to the default settings, except for
some settings of network, ratings, remote control
code, language, etc.
A Volume (Channel balance)
B Delay time for the Center speaker
C Delay time for the Surround and Surround
back speakers*
* Surround back speakers: optional ( > 10)
∫ Adjusting speaker level
(Effective when playing multi-channel audio)
1
Select “Test” and press [OK].
A test signal is output.
2 While listening to the test signal
Press [
3, 4] to adjust the volume of each
speaker ( ).
The volume can be adjusted between r6 dB
to s6 dB.
≥ Set each speaker level according to the
volume of the Front (L) and Front (R)
speaker volume respectively.
3 Press [OK].
The test signal stops.
Speaker settings
0
0 0
0.0
0.0
ms
Complete
Test
LS
R L
RS
dB
dB dB
ms
C
0
dB
SW



dB
0
SC-BTT490P_eng.book 40 ページ ２０１２年２月２２日 水曜日 午前９時１分