Patton electronic SmartNode 4650 - Manual (Page 4)

4 SmartNode 4650 G.SHDSL Quick Start Guide
3.2 Login
1. To access the SmartNode, start the Telnet application on your PC. Type the default IP address into the
address field:
192.168.1.1 . Accessing your SmartNode via a Telnet session displays the login screen.
Type the factory default login: administrator and leave the password empty. Press the Enter key after the
password prompt.
login: administrator
password:<Enter>
192.168.1.1>
2. After you log in, your SmartNode will be running in operator execution mode (indicated by > character
in the command line prompt). To enter configuration mode, use the commands
enable and configure .
192.168.1.1> enable
192.168.1.1# configure
192.168.1.1(cfg)#
4.0 Connecting the SmartNode to the network
In general, the SmartNode will connect to the network via the WAN (ETH 0/0) port. This enables the SmartNode
to offer routing services to the PC hosts on LAN (ETH 0/1) port. The SmartNode 4650 Series provides an auto-
MDX feature for both Ethernet ports, so you can use a straight-through or cross-over cable to connect to a host or
a switch (see
figure 2 ).
The interconnecting cables shall be acceptable for external use and shall be rated for
the proper application with respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
CAUTION