Poulan EBVM 215 - Manual (Page 8)

8
USING YOUR UNIT
KNOW YOUR ELECTRIC BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Compare the illustrations to your unit to familiarize yourself with the location of
the various controls and adjustments. Save this manual for future reference.
Top Handle
Air Vents
ON/OFF Switch
Inlet Cover
Latch
Rear
Handle
Upper Vacuum Tube
Lower Vacuum Tube
Collection Bag
Blower Tube
Cord
Retainer
Inlet Restrictor
Vacuum Assist Handle
Tube Release Button
Elbow
Tube
Upper Vacuum Tube
Retaining Post
ON/OFF SWITCH
The
ON/OFF SWITCH is used to activate
the motor.
INLET COVER LATCH
The
INLET COVER LATCH is used to open
and close the inlet cover and to secure
the upper vacuum tube to the blower
unit.
BLOWER TUBE
The
BLOWER TUBE is designed to direct
the flow of air.
INLET RESTRICTOR
The
INLET RESTRICTOR improves the
blower function.
TUBE RELEASE BUTTON
The
TUBE RELEASE BUTTON secures the
blower tube or elbow tube to the blower
unit during operation. Also, pressing the
tube release button allows removal of the
blower tube or elbow tube.
WARNING: You MUST make sure
the tubes are secure before using the
unit.
WARNING: Do not use the unit
without the tubes or collection bag proper-
ly attached to avoid flying debris and/or
impeller contact which can cause serious
injury. Always wear eye protection to pre-
vent rocks or debris from being blown or
ricocheting into the eyes and face which
can result in blindness or serious injury.
STOPPING YOUR UNIT
Slide the
ON/OFF switch to the OFF
position.
STARTING YOUR UNIT
Your unit has two run positions,
LOW
and HIGH . Slide the switch to one of
these positions to turn on the unit.
OPERATING POSITION
Blower
Eye Protection
Vacuum
Eye Protection