Panasonic SC-HT900 - Manual (Page 11)

11
RQT6750
S
imple
set
up
[HT900]
(Center speaker only)
[HT700] [HT690]
[Note]
The wall or pillar on which the speakers are to be attached should
be capable of supporting 10 kg (22 Ib.) per screw.
Remove the stand.
( [HT900] only)
BEFORE REMOVING THE STAND
≥Take the speaker cable out of the stand’s hole if it is threaded
through.
≥Lay the speaker on a soft cloth.
Unscrew the screw with a Phillips-head screwdriver.
1
Screw a screw (not included) into the
wall.
2
Fit the speaker securely onto the
screw with the hole or holes.
[HT900]
(Center speaker only)
[HT700] [HT690]
Preparation
Remove the stand (
[HT900] only).
Ensure the stands meet these conditions before purchasing them.
≥Observe the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥The stands must be able to support over 10 kg (22 lb.).
≥The stands must be stable even if the speakers are in a high
position.
Notes on speaker use
≥You can damage your speakers and shorten their useful life if you
play sound at high levels over extended periods.
≥Reduce the volume in the following cases to avoid damage.
–When playing distorted sound.
–When the speakers are receiving howling from a record player,
noise from FM broadcasts, or continuous signals from an
oscillator, test disc, or electronic instrument.
–When adjusting the sound quality.
–When turning the unit on or off.
If irregular coloring occurs on your television
These speakers are designed to be used close to a television, but
the picture may be affected with some televisions and setup
combinations.
If this occurs, turn the television off for about 30 minutes.
The television’s demagnetizing function should correct the problem.
If it persists, move the speakers further away from the television.
Other speaker setup options
Attaching to a wall
Stand
30–35 mm
(1
3 / 16
q–1 3 / 8
q)
Wall
‰7.5–9.4 mm
(
19 /
64
q– 3 /
8
q)
8–11 mm
(
3 / 8
q– 7 / 16
q)
Vertical Horizontal
100 mm
(3 15 / 16
q)
Fitting speaker stands (optional)
5 mm ( 13 /
64
q), pitch 0.8 mm ( 1 /
32
q)
60 mm (2 23 /
64
q)
Speaker stand
(not included)
Attach the stands
with these holes. Plate thickness plus 7 to
10 mm (plus
9 / 32
q to 25 / 64
q)
Caution
≥Use the speakers only with the
recommended system. Failure to do
so may lead to damage to the
amplifier and/or the speakers, and
may result in the risk of fire. Consult
a qualified service person if damage
has occurred or if you experience a
sudden change in performance.
≥Do not attempt to attach these
speakers to walls using methods
other than those described in this
manual.