Panasonic CQ-C1301U - Manual (Page 7)

Preparation
1
Set your car's ignition switch to the ACC or
ON position.
The demonstration screen appears.
2
Press [DISP] (Display).
The demonstration screen is canceled, and no more
appears.
3
Press [SRC] (PWR: Power).
Note: If you would like to turn on the power and make the
demonstration message appear, hold down [SRC] (PWR)
for more than 4 seconds.
The 12-hour system is used for the clock.
1
Press [DISP] (CLOCK).
(clock display)
2
Hold down [DISP] (CLOCK) for more than 2
seconds.
Hours blinks
3
Adjust the hour.
Hours set
[ []: sets the hour ahead.
[
]]: sets the hour back.
4
Press [DISP] (CLOCK).
Minutes blinks
5
Adjust the minute.
Minutes set
[
[]: sets the minute ahead.
[
]]: sets the minute back.
6
Press [DISP] (CLOCK).
Complete
Notes:
¡ “ADJUST” is displayed before adjusting the clock.
¡ Hold down [ ]]
or [ []
to change numbers rapidly.
Clock Display at Power Off
Press [DISP] to change the display.
Clock Setting
Display off
Clock display
ACC
ON
Batter
y
Installation
Pull the insulation film out from the
backside of the remote control
gently.
nly
Note: Battery Information:
Battery Type: Panasonic lithium battery (CR2025) (Included in
the remote control)
Battery Life: Approximately 6 months under normal use (at
room temperature)
First T
ime Power On