Pioneer PRV-9200 - Manual (Page 51)

Recording 06
51
En
1 Press ‘VCR Plus+’ to display the VCR Plus+
program screen.
You can also access this screen from the Home Menu
(press
HOME MENU, select Timer Recording, then VCR
Plus+).
• Use the number buttons to enter the PlusCode
number. (To clear the last digit entered, press
CLEAR.)
• Press REC MODE to select FINE, SP, LP, EP or AUTO
(See Recording time and picture quality on page 45). If
Manual Recording is on, then you can also select the
MN setting.
• Use the / (cursor left/right) buttons to select the
Once, Daily or Weekly recording option.
• Press HDD to record to the hard disk drive, or DVD to
record to a DVD.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven’t set up the guide channels (or at least
the guide channel for the PlusCode number that you
entered), the recorder will prompt you to enter the
channel number that the TV program is showing on.
Tip
• You can check the timer program settings by
pressing TIMER REC to display the timer recording
screen.
VCR Plus+ programming with the power off
You can enter a PlusCode number when the recorder is
in standby. Note that the recording is always made to the
HDD. If you want to record to a DVD disc, you’ll need to
switch on the power and use the full VCR Plus+ program
screen.
Important
• You can’t use this feature until you have set up the
guide channels. See VCR Plus+ CH Setting on
page 97.
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1 Press ‘VCR Plus+’.
The front panel display shows the current recording
mode and prompts you to enter the PlusCode number.
2 Use the number buttons to enter the PlusCode
number.
• To clear the last digit entered, press CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date
Start time End time HDD and Recording
channel.
• If CODE ERROR appears in the display, check that
the PlusCode number is correct and that the guide
channel is set (see
VCR Plus+ CH Setting on
page 97), then set the timer recording again.
• If CAN’T SET appears in the display, it means that
although you entered a valid PlusCode number, the
program has already finished.
to input 3 9 9 2 4 0 9 PlusCode#
Rec Mode
Rec Times
VCR Plus+
MN21
Once Daily Weekly
REC MODE to change
to change level
to change
Rec to HDD HDD DVD to change
ENTER
CLEAR
VCR Plus+
P L US CODE
2 9 32 4