Patton electronic 3087 - Manual (Page 5)

Model 3087 Quick Start Guide 5
4.0 Log onto the GUI web management page
You will now access the web management graphical user interface (GUI) to configure the ipRocketLink using a
standard web browser (such as Netscape or Internet Explorer).
1. At your PC, open a web browser and enter the IP address you assigned to the ipRocketLink’s Ethernet LAN
port in step 2 of
2.2 “Modify the IP address” .
2. Log into the web management home page using the username superuser and the password superuser .
(See figure 3 .)
Figure 3. Model 3087 web management home page
5.0 Connect to the G.SHDSL Port
1. Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.
2. Plug one end of the cable into the (yellow) RJ-11 socket (labeled DSL ) on the ipRocketLink Integrated
Access Device.
3. Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.
4. When a DSL link is established, the front-panel WAN LINK LED will turn on.
6.0 Connect the serial port
Your ipRocketLink is equipped with one of the following serial WAN ports for connection to an NTU:
• V.35 (M/34 or DB-25) – Model 3087/RIC/EUI
• X.21 (DB-15) – Model 3087/RID/EUI
• T1/E1(RJ-48C and dual BNC) – Moel 3087/RIC/EUI