PYLE Audio PYLE VIEW PLVWH2 - Manual (Page 4)

3
5. Receiving Positions
The headphone / Receiver receives audio signals omni-directionally
and in line-of-sight within certain effective ranges.
For best reception, use th headphone. within 5 meters from the emitter
of the transmitter.
1. Turn on the audio/video equipment
connected to the transmitter. 2. Turn on the power switch for
headphone.
3. Adjust volume control on the
left side. Do not cover the sensors
while adjusting volumes. 4. Turn on the stereo switch for
stereo effect. For Mono
audio/video equipment, turn
the switch to the mono position.
Specifications:
How to use
* Infrared Wave-Lenght: 850mm
* Modulation: Frequency Modulation
* Carrier Frequency: L-ch ---- 2.3 MHz
R-ch ---- 2.80 MHz
Transmitter:
* Input Voltage: 12 VDC +-2V
* Current: <80mA
* IF Frequency: L-ch --- 2.3 MHz +-15KHz
R-ch --- 2.80 MHz +-15KHz
* Impedance: 10K ohm +-15%
* Auto. On Lever: Less Than 30 mV (input: 1KHz)
* Auto. Off Time: 120 Sec - 240 Sec
* Connecting Pin Wiring Source: (1) Ground (2) Left Ch (3) Right Ch.
(4) GND (5) +12V