PAC SWI-JACK - Manual (Page 3)


06-08-09
Step 5.
Refer to The Vehicle Application Guide. Note the INTERFACE Version Number next to the selected vehicle. Fill in the information
below for quick reference. The Radio Select Switch must be set BEFORE programming the INTERFACE version number. Set the
switch as follows: Alpine = 1, JVC = 2, Kenwood = 3, Clarion = 4 Valor = 5 OEM = 6 and Blaupunkt = 7
Version Number: ____________
SWI-JACK
SWI-JACK
Programming the SWI-JACK to Work With the Vehicle
Step 6.
Press and hold programming/
mode button on SWI-JACK. Turn
the vehicle ignition to the ON
position.
The LED on the
SWI-JACK will light.
Step 7.
Release the programming/
mode button.
The LED will turn off,
indicating memory is
cleared.
Step 9.
Press and release the program-
ming/mode button the same
number of times as the desired
version number.
The LED will flash
each time the button is
pressed and released.
After  seconds, the
LED will flash the same
amount of times of set
version number.
Step 10.
Turn vehicle ignition
to OFF position.
Vehicle programming
sequence is complete.
SWI-JACK
OFF
ACC
IGN
STRT
OFF
ACC
IGN
STRT
SWI-JACK
SWI-JACK
SWI-JACK
(Write Version Number here)
SWI-JACK