Primera Technology 810 - Manual (Page 2)

Step 1
Place the rubber stoppers so
that the middle hole is facing
up.
Step 2
Mount the LX Printer on top
by inserting into the rubber
stoppers.
Step 3
Remove the outer side disk by
loosening the black screw.
Step 4
Load an empty core.
Step 5
To adjust the core diameter,
loosen the screw on the side
disc and rotate the two fixed
knobs together to expand the
diameter.
Step 6
Feed the label under the arm
and attach it to the core.
Step 7
Install the disc on the other
side and adjust to fit the core
diameter as described
in Step 5.
Step 8
Tighten the side disc with the
screw against the shaft.
Step 9
Make sure the disc screw is
fixed.
Step 10
Install the arm support if
necessary by sliding into the
position.
Step 11
Tighten the support with
screw.
Step 12
Turn on the power. The LX-
Rewinder is now ready to
rewind your labels.
w w w . p r i m e r a . c o m • • w w w . p r i m e r a - e u r o p e . e u
How to Install the LX-Rewinder