Polk Audio Sirius Satellite Radio Tuner SRH1000 - Manual (Page 47)

Note: If the channel list has not yet been downloaded from the SIRIUS
data stream, an Updating City List notification screen will be displayed.
Wait 10 minutes and then try selecting a city again.
Setting The Jump Button To A Channel
To Set The Jump Button To Any Channel Other Than A Traffic Channel:
1. Select the JumpSet menu option. (Figure 6)
2. Press the MENU button to exit the menu options and return to the
Default display screen. The jump button can now be programmed
by tuning to your desired channel and pressing and holding the
Jump button for two seconds, as described in the Setting Channel
Presets section.
Display Options
The brightness and contrast of the receiver’s display screen
may be adjusted. To Adjust These Settings:
1. Select the Display Options menu option.
2. Select one of the following two options:
Brightness—You can set the brightness for the LCD backlight
and keypad. Use the CHANNEL (
) buttons to adjust the
brightness up or down. The bar graph at the bottom of the display
screen will move to indicate the change.
Contrast—This setting adjusts the relationship between the back
ground and the text on the LCD display screen. Use the CHANNEL
(
) buttons to adjust the contrast up or down. The bar graph at
the bottom of the display screen will move to indicate the change.
Figure 8
Press the ENTER button to select the setting.
To exit Display Options, press the MENU button.
47 MENU OPTIONS