Patton electronic SmartNode 4830 Series User Manual
Getting started guide
Advertising
SmartNode 4830 Series
Analog VoIP Integrated Access
Device
Getting Started Guide
Sales Office:
+1 (301) 975-1000
Technical Support:
+1 (301) 975-1007
E-mail:
WWW:
Part Number:
07MSN4830-GS, Rev. D
Revised:
September 26, 2008
Approval
Models that are equipped with telecom interfaces have been approved for connection to the public telecommunication network as listed
under PSTN regulatory compliance.
Important
This is a Class A device and is intended for use in a light industrial environment. It is not intended nor approved for use in an industrial
or residential environment.
Advertising
Table of contents
Document Outline
- Summary Table of Contents
- Table of Contents
- List of Figures
- List of Tables
- About this guide
- Chapter 1 General information
- Chapter 2 Applications overview
- Chapter 3 Hardware installation
- Chapter 4 Getting started with the SmartNode
- Chapter 5 LEDs status and monitoring
- Chapter 6 DSL Basic Configuration
- Chapter 7 Contacting Patton for assistance
- Appendix A Compliance information
- Appendix B Specifications
- DSP
- Voice connectivity
- Ethernet interface
- Sync serial interface (if applicable)
- T1/E1 interface (if applicable)
- ADSL Daughter Card (if applicable)
- G.SHDSL Daughter Card (if applicable)
- PPP and Frame-Relay support
- Voice processing (signaling dependent)
- Fax and modem support
- Voice signaling
- Voice routing—session product
- IP services
- Management
- Operating environment
- System
- Dimensions
- Weight and power dissipation
- Power supply
- Identification of the SmartNode devices via SNMP
- Appendix C Cabling
- Appendix D Port pin-outs
- Appendix E Installation checklist
- Appendix F Accessories