PYLE Audio PYD-1005 - Manual (Page 9)

Pyle Pro Mixer Owner’s Manual – 7
Mixing the Inputs
Follow these steps to mix the audio input
sources.
1. Perform Steps 1 and 2 of “Turning on
the Mixer.”
2. Set the selected audio input source’s
volume to its minimum setting, turn
it on, and set it to play (or speak
continuously into the microphone).
3. Set the following input source selectors
as desired:
4. Set the Channel 1, Channel 2 and Channel 3
volume control sliders to approximately 8-10.
5. Rotate the Master Volume Control clockwise
until you observe an average reading of “0”
(zero) on both Output Level LED meters, and
leave it at that setting. (Please note that the
Output Level LED meter indicates the total
output signal being mixed from all sources for
each of the Left and Right channels.)
6. When adding an audio input source to the mix,
adjust the corresponding Channel 1, 2 and 3
volume control sliders so you maintain the
average reading of “0” on both Output Level
LED meters.
7. Adjust the receiver/amplifier volume control to
the desired volume.
8. To turn off the mixer, push the Power switch
to the OFF position; the Power LED will be
extinguished.
Input Source
Selector Switches
Input Source
Volume Control Sliders
Turntable connected to PHONO1
High level output audio source connected to the LINE 1 jacks
High level output audio source connected to the LINE 3 jacks
High level output audio source connected to the LINE 4 jacks
Mixer
Channel
Audio Input
Source
1
3
Turntable connected to PHONO2
High level output audio source connected to the LINE 2 jacks
2