Pella Replacement Window 80YV0102 - Manual (Page 13)

LOCK LEVER REMOVAL AND INSERTION
Note: You may want to remove the lock lever if it needs to be replaced with a different
finish.
A. Unlock and open the window.
B. Place the lock lever in the
locked position.
C. From the exterior of the
window, look through the
opening behind the lock lever
to locate the point where the
lock lever and lock cam meet.
D. Insert an approximately 1/4" wide flat-blade screwdriver
straight into the opening and center the blade tip at the
point the cam and lever meet.
Interior
B
Stop removed to show
the lever and cam.
C
AWNING/
CASEMENT
E. Push the screwdriver against the lock cam and rotate
the bottom of the blade toward the lock lever. This will
push the lock cam away from the lock lever hook so
the lever can be removed.
F. Remove the lock lever by pulling it straight out toward
the interior of the building.
G. To install a lock lever, from the interior hold it in the
locked position and insert into the slot until it snaps onto
the cam.
Note: The lock cam must be in the locked position
before the lock lever can be inserted.
Stop removed to show
orientation of
screwdriver between
the lever and cam.
E
Interior
G