Panasonic SA-XR70 EN - Manual (Page 5)

5
St
ep 1
R
Q
T
7523
UT
P R
IN
DVR/VCR1
Y P B P R
Y P B P R
TV IN
DVD IN
COMPONENT VIDEO
FRONT B CENTER SURROUND
SPEAKERS (6 ∼8Ω) HAUT-PARLEURS
AC IN
∼
FRONT A
R L BACK R L
(DVD) IN
LF
R L
BI-WIRE HF
Class 2 Wiring
Connecting speakers
Front speakers (  left  right)
Place on the left and right of the TV at seated ear height so that there is
good coherency between the picture and sound.
Center speaker (  )
Place underneath or above the center of the TV. Aim the speaker at the
seating area.
Surround speakers (  left  right)
Place on the side of or slightly behind the seating area, about one meter
(3 feet) higher than ear level.
Surround back speaker (  )
Place behind the seating area, about one meter (3 feet) higher than ear
level.
Subwoofer (  )
The subwoofer can be placed in any position as long as it is at a
reasonable distance from the TV.
Note that some experimentation with positioning can yield the
smoothest low frequency performance. Placement near a corner can
increase the apparent output level, but can result in unnatural bass.
Cable Speaker terminals
Twist
the wire. FRONT Other terminals
Note If using 4-mm plugs
Do not short-circuit.
( )
( )
Peripheral equipment and cables sold separately unless otherwise indicated.
To connect equipment, refer to the appropriate operating instructions.

Front
right

Front
left

Surround
right

Surround
left

Surround
back
Speakers
Speaker
impedance:
Front A: 6-8 Ω
A and B:
6-8 Ω
Center: 6-8 Ω
Surround: 6-8 Ω

Center
Active
subwoofer

Monaural
connection
cable
Connect this cord after all other cables
and cords are connected.
Note
• The included AC power supply cord is for
use with this unit only. Do not use it with
other equipment.
• Do not use an AC power supply cord
from any other type of equipment with
this unit.
• If the unit is left unplugged for longer than
two weeks, all settings will revert to the
factory settings. Do the settings again if
this occurs.
Household AC outlet
(AC 120 V/60 Hz)
Speakers/
AC power supply cord
AC power
supply cord
(included)
Fully tighten the terminal,
then insert.