Parasound C/DP-2000 - Manual (Page 6)

-6-
Making Connections to your C/DP-2000 Ultra
Before making any connections, turn off the power to your preamplifier and power amplifier. Once the inputs
have been connected, plug the AC cord into any convenient outlet.
Analog Output Connections
There are two analog output connections on the rear panel of your C/DP-2000 Ultra: RCA connectors for
unbalanced line outputs and XLR connectors for balanced line outputs. You may use the RCA and XLR
connectors simultaneously if you wish.
RCA Jacks
Connect the left and right RCA output jacks to any line level RCA input on your preamplifier with a pair of
high-quality audio interconnect cables.
XLR Jacks
Connect the left and right XLR output jacks to the XLR input on your preamplifier if it is so equipped. The
industry standard pin assignment for the XLR connectors are: Pin 1 Ground, Pin 2 + signal, and Pin 3 - signal.
AC Power Connection
Your C/DP-2000 Ultra has an audiophile quality IEC standard detachable power cord. Try to connect this
cord directly to a nearby AC wall outlet and avoid extension cords or connection to accessory outlets on your
preamp.
Digital Output Connection
75
Ω
Coaxial Digital Connection
Your C/DP-2000 Ultra is equipped with an RCA jack for 75
Ω
coaxial digital connection to an external
D-A converter. Use a 75
Ω
digital cable designed for data transmission; a standard audio interconnect cable
will degrade data transmission and sonic quality.
External Remote Control Connection
Your C/DP-2000 Ultra has a rear mounted remote control connection that accepts the input of any popular
infrared repeater system to facilitate remote control operation from another room or when your player is
installed within a closed cabinet. This connector is a popular 1/8" (3.5 mm) mini jack and its center conductor
is +, the outer is - . For further details about IR control systems, contact your Parasound dealer or custom
installer.