Pella 80GY0102 - Manual (Page 6)

A. Apply side flashing tape. Cut two pieces of flashing tape 5" longer than
the frame height of the window. Apply the tape 1/2" onto the frame
cladding, over the fin and laps onto the water resistive barrier. The tape
should extend 2" above the top of the window and 3" below the bottom
of the window. Press the tape down firmly while folding down the excess
tape at the top and bottom of the window.
"
#


#
$
%
%
B. Apply top flashing tape. Cut two pieces of flashing tape long enough
to go across the top of the window and extend 1" past the flashing
tape on both sides. Apply the tape 1/2" onto the frame cladding,
over the top nailing fin and onto the water resistive barrier.
Press the tape down firmly. Apply the second piece of
tape just above and overlapping the first piece of
flashing tape by 1". Press the tape down firmly.
Fold the overlapping tape down, and press all
tape down firmly.
C. Fold down top flap of water resistive barrier (4C).
D. Apply flashing tape to diagonal cuts. Cut
pieces of flashing tape at least 1" longer than the
diagonal cuts in the water resistive barrier. Apply
the tape covering the entire diagonal cut in the
water resistive barrier at both upper corners of
the window.
Note: Be sure to overlap the top corners (4D).
5
SECURING THE WINDOW -
FRAME SCREW INSTALLATION
Note: If installing the window using installation clips, proceed to Step 6 -
INSTALLATION CLIP METHOD
A. Fixed windows only: On the room
side of fixed windows are a series of
screws which secure the sash into the
frame. ONE AT A TIME, remove each
screw, drill a 1/8" x 1" deep pilot hole
into the rough framing, then insert a
#10 x 3-1/2" corrosion resistant wood
screw. Proceed to Step 6.
Warning: Removing more than one
screw at a time could allow the sash
to break free from the window frame
which could result in damage to the
sash and/or create the potential for
personal injury.

Y


DPSSPTJPO
SFTJTUBOU
XPPE
TDSFX
"